Hi Speed Door

Control systems

Japanese Mitsubishi Inverter, PLC and other components.
Dynamical systems€
Adopt special high-speed motor reducer,0.75-2.2KW, according to the size of the door to select
the model.two brand for choice,SNMA or SEW.Incorporating limit switches for open and close
cycles, and this drive unit can be used on manual in the event of power failure
Door construction
Framework-------In 2mm thicknesses cold-roll steel sheets of Shanghai Baosteel, Or on
request,In stainless steel INOX304,paint according to your order
Rolling shaft---------In 2mm thicknesses cold-roll steel tube with machined blocks at each and
incorporating high-speed bearing
Cross bar-------In aluminum lath
Curtain------made in high-density polyester fabric.
Thinkness:0.8mm or 1.5mm
Self-extinguishing rate: DIN4102
Colour:yellow, blue, red, white, orange and other color for selection.
transparent window------ -use transparent pvc film imported from Japan, various styles ,size and
location according to your order.thinkness:1.5mm
Command systems
radar sensor
pull cord
remote control
magnetic loop
push buttom
safe systems
Photoelectric sensor-------installed on the side tracks, with emergency stopping reaction when
sensing obstacles
Safe edge bottom-------when the people or vehicle touch the bottom edge of falling door,it bound
up automatically
Emergency stop protection------with emergency stop buttom on control panel
Seal
seal brush are Installed inside the guides, besides,there is trap heavier fabric on the bottom,
close to any uneven ground
Technical parameter
Power supply: single phase:220V /three phase:380 50Hz
Power consumption: max 250W
Opening & closing speed: 0.7-1.7m/s (optionally different opening speed upon request)
Opening & closing frequency:1000-1500cycles/day
Wind load:20m/s
Ambient temperature:-20? to +50?